This makes clk2fflogic add an attr to $ff cells that carry the state of
the emulated async FF. The $ff output doesn't have any async updates
that happened in the current cycle, but the $ff input does, so the $ff
input corresponds to the async FF's output in the original design.
Hence this patch also makes the following changes to passes besides
clk2fflogic (but only for FFs with the clk2fflogic attr set):
* opt_clean treats the input as a register name (instead of the
output)
* rename -witness ensures that the input has a public name
* the formal backends (smt2, btor, aiger) will use the input's
name for the initial state of the FF in witness files
* when sim reads a yw witness that assigns an initial value to the
input signal, the state update is redirected to the output
This ensures that yosys witness files for clk2fflogic designs have
useful and stable public signal names. It also makes it possible to
simulate a clk2fflogic witness on the original design (with some
limitations when the original design is already using $ff cells).
It might seem like setting the output of a clk2fflogic FF to update the
input's initial value might not work in general, but it works fine for
these reasons:
* Witnesses for FFs are only present in the initial cycle, so we do
not care about any later cycles.
* The logic that clk2fflogic generates loops the output of the
genreated FF back to the input, with muxes in between to apply any
edge or level sensitive updates. So when there are no active updates
in the current gclk cycle, there is a combinational path from the
output back to the input.
* The logic clk2fflogic generates makes sure that an edge sensitive
update cannot be active in the first cycle (i.e. the past initial
value is assumed to be whatever it needs to be to avoid an edge).
* When a level sensitive update is active in the first gclk cycle, it
is actively driving the output for the whole gclk cycle, so ignoring
any witness initialization is the correct behavior.
* xilinx: add SCC test for DSP48E1
* xilinx: Gate DSP48E1 being a whitebox behind ALLOW_WHITEBOX_DSP48E1
Have a test that checks it works through ABC9 when enabled
* abc9 to break SCCs using $__ABC9_SCC_BREAKER module
* Add test
* abc9_ops: remove refs to (* abc9_keep *) on wires
* abc9_ops: do not bypass cells in an SCC
* Add myself to CODEOWNERS for abc9*
* Fix compile
* abc9_ops: run -prep_hier before scc
* Fix tests
* Remove bug reference pending fix
* abc9: fix for -prep_hier -dff
* xaiger: restore PI handling
* abc9_ops: -prep_xaiger sigmap
* abc9_ops: -mark_scc -> -break_scc
* abc9: eliminate hard-coded abc9.box from tests
Also tidy up
* Address review
N. Engelhardt
Claire Xenia Wolf
Jannis Harder
Benjamin Barzen
AdamHillier
Miodrag Milanovic
Lofty
Eddie Hung
N. Engelhardt
whitequark