In previous implementation, it was known that it does not perform
full reset, and that some peripherals, such as GLB core,
which handles among other stuff GPIOs, was not reset.
It was presumed, that full reset by software is not possible,
although, by accident, even when comment says that
CTRL_PWRON_RESET is set to 1, it is not
(value written into 0x40000018 supposed to be 0x7, not 0x6).
CTRL_PWRON_RESET indeed triggers full "power-on like" reset,
so this method is implemented in this commit.
There are some workarounds to make reset seamless, without any
error messages, which are described in comments of TCL script.
Only down-side of this reset is, that chip is halted after reset
bit later in BootROM than previous implementation,
but it's still good.
Change-Id: Ife2cdcc6a2d96a2e24039bfec149705baf046318
Signed-off-by: Marek Kraus <gamelaster@outlook.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/8529
Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
Tested-by: jenkins
Adds initial support for the BL702 series of chips, BL702, BL704 and BL706.
No flash bank support yet.
File name bl702.tcl was chosen over bl70x.tcl, because Bouffalo Lab
uses bl702 to mark the whole series in many of their tools.
The ndmreset bit in the RISC-V Debug Module isn't implemented correctly,
so it doesn't trigger a system reset as it should.
To solve this problem, the software reset is implemented
in the reset-assert-pre hook, which uses best reset method I could find.
What is not reset is the GLB core, which handles GPIOs, pinmux, etc.
The reset mechanism has been extensively tested, and works correctly
for both "reset run" and "reset halt", which the latter
halts very early in the BootROM.
Change-Id: I5ced6eb3902d1b9d9c1bba56f817ec5dc3493cb0
Signed-off-by: Marek Kraus <gamelaster@outlook.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/8407
Tested-by: jenkins
Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
Marek Kraus