riscv-openocd/tcl/target/klx.cfg

#
# Freescale Kinetis KL series devices
#

source [find target/swj-dp.tcl]

if { [info exists CHIPNAME] } {
    set _CHIPNAME $CHIPNAME
} else {
    set _CHIPNAME klx
}

# Work-area is a space in RAM used for flash programming
# By default use 4kB
if { [info exists WORKAREASIZE] } {
   set _WORKAREASIZE $WORKAREASIZE
} else {
   set _WORKAREASIZE 0x1000
}

if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
} else {
    set _CPUTAPID 0x0bc11477
}

swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m -chain-position $_CHIPNAME.cpu

$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0

set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME kinetis 0 0 0 0 $_TARGETNAME

# Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual
# specifies up to 1MHz for VLPR mode.
adapter_khz 1000

reset_config srst_nogate

if {![using_hla]} {
   # Detect secured MCU or boot lock-up in RESET/WDOG loop
   $_CHIPNAME.cpu configure -event examine-start {
      kinetis mdm check_security
   }

   # if srst is not fitted use SYSRESETREQ to
   # perform a soft reset
   cortex_m reset_config sysresetreq
}

# Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual
# specifies up to 24MHz for run mode; Table 17 of Sub-Family Data
# Sheet rev4 lists 25MHz as the maximum frequency.
# Uncoment only if VLPR mode is not used
#$_TARGETNAME configure -event reset-init {
#   adapter_khz 24000
#}