Name,Description,Flags,Value,Unit
(m3.-),"| Algorithm should flag errors, for met3, if ANY of the following is true:
| An entire 700x700 window is covered by cmm3 waffleDrop, and metX PD < 70% for same window.
| 80-100% of 700x700 window is covered by cmm3 waffleDrop, and metX PD < 65% for same window.
| 60-80% of 700x700 window is covered by cmm3 waffleDrop, and metX PD < 60% for same window.
| 50-60% of 700x700 window is covered by cmm3 waffleDrop, and metX PD < 50% for same window.
| 40-50% of 700x700 window is covered by cmm3 waffleDrop, and metX PD < 40% for same window.
| 30-40% of 700x700 window is covered by cmm3 waffleDrop, and metX PD < 30% for same window.
| Exclude cells whose area is below 40Kum2. NOTE: Required for IP, Recommended for Chip-level.",RC,,
(m3.1),Width of metal 3,,0.300,µm
(m3.2),Spacing of metal 3 to metal 3,,0.300,µm
(m3.3a),Min. spacing of features attached to or extending from huge_met3 for a distance of up to 0.480 um to metal3  (rule not checked over non-huge met3 features),,N/A,N/A
(m3.3b),Min. spacing of huge_met3 to metal3 excluding features checked by m3.3a,,N/A,N/A
(m3.3c),Min. spacing of features attached to or extending from huge_met3 for a distance of up to 0.400 µm to metal3  (rule not checked over non-huge met3 features),,0.400,µm
(m3.3d),Min. spacing of huge_met3 to metal3 excluding features checked by m3.3a,,0.400,µm
(m3.4),Via2 must be enclosed by Met3 by at least …,AL,0.065,µm
(m3.5),Via2 must be enclosed by Met3 on one of two adjacent sides by at least …,,N/A,N/A
(m3.5a),Via2 must be enclosed by Met3 on all sides by at least …(Rule not checked on a layout when it satisfies both rules m3.4 and m3.5),,N/A,N/A
(m3.6),Min area of metal3,,0.240,µm²
(m3.7),Min area of metal3 holes,CU,0.200,µm²
(m3.pd.1),Min MM3_oxide_Pattern_density,RR,0.7,\-
(m3.pd.2a),Rule m3.pd.1 has to be checked by dividing the chip into square regions of width and length equal to …,A,700,µm
(m3.pd.2b),Rule m3.pd.1 has to be checked by dividing the chip into steps of …,A,70,
(m3.11),Max width of metal3,CU,4.000,µm
(m3.12),Add slots and remove vias and contacts if wider than…..,CU,3.200,
(m3.13),Max pattern density (PD) of metal3,CU,0.77,\-
(m3.14),Met3 PD window size,CU,50.000,µm
(m3.14a),Met3 PD window step,CU,25.000,µm
(m3.15),Via2 must be enclosed by met3 by at least…,CU,0.060,µm