/* * SPDX-FileCopyrightText: 2020 Efabless Corporation * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. * SPDX-License-Identifier: Apache-2.0 */ #include #include #include #include #include #include extern uint16_t flag; void main(){ flag = 0; reg_wb_enable =1; // for enable writing to reg_debug_1 and reg_debug_2 reg_debug_1 = 0x0; reg_debug_2 = 0x0; reg_mprj_io_6 = GPIO_MODE_MGMT_STD_OUTPUT; reg_mprj_io_5 = 0x1803; if(1){ reg_mprj_xfer = 1; while (reg_mprj_xfer == 1); } reg_uart_enable = 1; reg_uart_irq_en =1; irq_setmask(0); irq_setie(1); irq_setmask(irq_getmask() | (1 << UART_INTERRUPT)); reg_debug_2 = 0xAA; //start sending data through the uart print("M"); // Loop, waiting for the interrupt to change reg_mprj_datah bool is_pass = false; int timeout = 100; for (int i = 0; i < timeout; i++){ if (flag == 1){ reg_debug_1 = 0x1B; //test pass irq sent is_pass = true; break; } } if (!is_pass){ reg_debug_1 = 0x1E; // timeout } // test interrupt doesn't happened nothing sent at uart reg_debug_2 = 0xBB; flag = 0; // Loop, waiting for the interrupt to change reg_mprj_datah is_pass = false; for (int i = 0; i < timeout; i++){ if (flag == 1){ reg_debug_1 = 0x2E; //test fail interrupt isn't suppose to happened is_pass = true; break; } } if (!is_pass){ reg_debug_1 = 0x2B; // test pass } // test finish reg_debug_2 = 0xFF; }