// SPDX-FileCopyrightText: 2020 Efabless Corporation // // Licensed under the Apache License, Version 2.0 (the "License"); // you may not use this file except in compliance with the License. // You may obtain a copy of the License at // // http://www.apache.org/licenses/LICENSE-2.0 // // Unless required by applicable law or agreed to in writing, software // distributed under the License is distributed on an "AS IS" BASIS, // WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. // See the License for the specific language governing permissions and // limitations under the License. // SPDX-License-Identifier: Apache-2.0 `default_nettype none // This module represents an unprogrammed set of GPIO pad default // values that is configured with via programming on the chip top // level. This value is passed as a set of parameters (formerly // part of gpio_control_block.v). module gpio_defaults_block #( // Parameterized initial startup state of the pad. The default // parameters if unspecified is for the pad to be a user input // with no pull-up or pull-down, so that it is disconnected // from the outside world. See defs.h for configuration word // definitions. parameter GPIO_CONFIG_INIT = 13'h0402 ) ( `ifdef USE_POWER_PINS inout VPWR, inout VGND, `endif output [12:0] gpio_defaults ); wire [12:0] gpio_defaults; wire [12:0] gpio_defaults_high; wire [12:0] gpio_defaults_low; // For the mask revision input, use an array of digital constant logic cells sky130_fd_sc_hd__conb_1 gpio_default_value [12:0] ( `ifdef USE_POWER_PINS .VPWR(VPWR), .VPB(VPWR), .VNB(VGND), .VGND(VGND), `endif .HI(gpio_defaults_high), .LO(gpio_defaults_low) ); genvar i; generate for (i = 0; i < 13; i = i+1) begin assign gpio_defaults[i] = (GPIO_CONFIG_INIT & (13'h0001 << i)) ? gpio_defaults_high[i] : gpio_defaults_low[i]; end endgenerate endmodule `default_nettype wire