61 lines
2.5 KiB
Plaintext
61 lines
2.5 KiB
Plaintext
# Run VPR for the 'and' design
|
|
# When the global clock is defined as a port of a tile, clock routing in VPR should be skipped
|
|
# This is due to the Fc_in of clock port is set to 0 for global wiring
|
|
# The constant net such as logic '0' and logic '1' must be routed because current architecture cannot produce them locally
|
|
# Enable block usage in log file, otherwise QoR check in OpenFPGA flow-run will fail
|
|
vpr ${VPR_ARCH_FILE} ${VPR_TESTBENCH_BLIF} --route_chan_width ${VPR_ROUTE_CHAN_WIDTH} --constant_net_method route --write_block_usage ${OPENFPGA_VPR_PACK_STATS_FILE}
|
|
|
|
# Read OpenFPGA architecture definition
|
|
read_openfpga_arch -f ${OPENFPGA_ARCH_FILE}
|
|
|
|
# Read OpenFPGA simulation settings
|
|
read_openfpga_simulation_setting -f ${OPENFPGA_SIM_SETTING_FILE}
|
|
|
|
# Annotate the OpenFPGA architecture to VPR data base
|
|
# to debug use --verbose options
|
|
# Note: no need to assign activity file when you used a fixed number
|
|
# of clock cycles in simulation settings
|
|
# Also, ACE2 does not support multiple clocks
|
|
# Therefore, activity file is not recommended for multi-clock fabric/implementations
|
|
link_openfpga_arch --sort_gsb_chan_node_in_edges
|
|
|
|
# Check and correct any naming conflicts in the BLIF netlist
|
|
check_netlist_naming_conflict --fix --report ./netlist_renaming.xml
|
|
|
|
# Apply fix-up to Look-Up Table truth tables based on packing results
|
|
lut_truth_table_fixup
|
|
|
|
# Build the module graph
|
|
# - Enabled compression on routing architecture modules
|
|
# - Enabled frame view creation to save runtime and memory
|
|
# Note that this is turned on when bitstream generation
|
|
# is the ONLY purpose of the flow!!!
|
|
build_fabric --compress_routing --frame_view #--verbose
|
|
|
|
# Write the fabric hierarchy of module graph to a file
|
|
# This is used by hierarchical PnR flows
|
|
write_fabric_hierarchy --file ./fabric_hierarchy.txt
|
|
|
|
# Repack the netlist to physical pbs
|
|
# This must be done before bitstream generator and testbench generation
|
|
# Strongly recommend it is done after all the fix-up have been applied
|
|
repack #--verbose
|
|
|
|
# Build the bitstream
|
|
# - Output the fabric-independent bitstream to a file
|
|
# Skipped becasue it takes long time to run for bigger fabric
|
|
# --write_file fabric_independent_bitstream.xml
|
|
build_architecture_bitstream --verbose
|
|
|
|
# Build fabric-dependent bitstream
|
|
build_fabric_bitstream --verbose
|
|
|
|
# Write fabric-dependent bitstream
|
|
write_fabric_bitstream --file fabric_bitstream.xml --format xml
|
|
|
|
# Finish and exit OpenFPGA
|
|
exit
|
|
|
|
# Note :
|
|
# To run verification at the end of the flow maintain source in ./SRC directory
|