# Run VPR for the 'and' design
#--write_rr_graph example_rr_graph.xml
vpr ${VPR_ARCH_FILE} ${VPR_TESTBENCH_BLIF} --clock_modeling route

# Read OpenFPGA architecture definition
read_openfpga_arch -f ${OPENFPGA_ARCH_FILE}

# Read OpenFPGA simulation settings
read_openfpga_simulation_setting -f ${OPENFPGA_SIM_SETTING_FILE}

# Annotate the OpenFPGA architecture to VPR data base
# to debug use --verbose options
link_openfpga_arch --activity_file ${ACTIVITY_FILE} --sort_gsb_chan_node_in_edges

# Use a stream  to run a few commands
# Check and correct any naming conflicts in the BLIF netlist
# Apply fix-up to Look-Up Table truth tables based on packing results
# Build the module graph
#  - Enabled compression on routing architecture modules
#  - Enable pin duplication on grid modules
# Write the fabric hierarchy of module graph to a file
# This is used by hierarchical PnR flows
# Repack the netlist to physical pbs
# This must be done before bitstream generator and testbench generation
# Strongly recommend it is done after all the fix-up have been applied
# Build the bitstream
#  - Output the fabric-independent bitstream to a file
# Build fabric-dependent bitstream
source --command_stream "check_netlist_naming_conflict --fix --report ./netlist_renaming.xml;lut_truth_table_fixup;build_fabric --compress_routing;write_fabric_hierarchy --file ./fabric_hierarchy.txt;repack;build_architecture_bitstream --verbose --write_file fabric_independent_bitstream.xml;build_fabric_bitstream --verbose"

# Write fabric-dependent bitstream
write_fabric_bitstream --file fabric_bitstream.bit --format plain_text

# Write the Verilog netlist for FPGA fabric
#  - Enable the use of explicit port mapping in Verilog netlist
write_fabric_verilog --file ./SRC --explicit_port_mapping --include_timing --print_user_defined_template --verbose

# Write the Verilog testbench for FPGA fabric
#  - We suggest the use of same output directory as fabric Verilog netlists
#  - Must specify the reference benchmark file if you want to output any testbenches
#  - Enable top-level testbench which is a full verification including programming circuit and core logic of FPGA
#  - Enable pre-configured top-level testbench which is a fast verification skipping programming phase
#  - Simulation ini file is optional and is needed only when you need to interface different HDL simulators using openfpga flow-run scripts
write_full_testbench --file ./SRC --reference_benchmark_file_path ${REFERENCE_VERILOG_TESTBENCH} --explicit_port_mapping --include_signal_init --bitstream fabric_bitstream.bit 
write_preconfigured_fabric_wrapper --embed_bitstream iverilog --file ./SRC  --explicit_port_mapping
write_preconfigured_testbench --file ./SRC --reference_benchmark_file_path ${REFERENCE_VERILOG_TESTBENCH} --explicit_port_mapping 

# Write the SDC files for PnR backend
#  - Turn on every options here
write_pnr_sdc --file ./SDC

# Write SDC to disable timing for configure ports
write_sdc_disable_timing_configure_ports --file ./SDC/disable_configure_ports.sdc

# Write the SDC to run timing analysis for a mapped FPGA fabric
write_analysis_sdc --file ./SDC_analysis

# Finish and exit OpenFPGA
exit

# Note :
# To run verification at the end of the flow maintain source in ./SRC directory