SDSD-8797:
WLAN (SDIO) firmware version: W14.68.29.p59
Bluetooth (SDIO) firmware version: 14.68.29.p59
The combo image can be downloaded through either WLAN or
Bluetooth.
USBUSB-8797:
WLAN (USB) firmware version: W14.68.29.p60
Bluetooth (USB) firmware version: 14.68.29.p60
The combo image can be downloaded through WLAN only.
PCIEUART-8997:
WLAN (PCIE) firmware version: W16.68.1.p179
Bluetooth (UART) firmware version: 16.26.1.p179
The combo image can be downloaded through WLAN only.
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
New in this release:
- Add support for Agilio LX cards
Improvements:
- Improve tunnel setup time in low traffic rate scenarios
Signed-off-by: Louis Peens <louis.peens@netronome.com>
Tested-by: Charles Murcott <charles.murcott@netronome.com>
Acked-by: Simon Horman <simon.horman@netronome.com>
This patch updates the firmware file for Intel Bluetooth 8265
Also it is known as Intel WindStormPeak (WsP).
FW Build: REL0299
Release Version: 21.0.0.4
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9260
Also it is known as Intel ThunderPeak (THP).
FW Build: REL0420
Release Version: 21.0.0.4
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9560
Also it is known as Intel JeffersonPeak (JfP).
FW Build: REL0420
Release Version: 21.0.0.4
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
The file was sent to me by Max Chou <max.chou@realtek.com>.
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Cc: Max Chou <max.chou@realtek.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
SDSD-8887:
WLAN (SDIO) firmware version: W15.68.7.p189
Bluetooth (SDIO) firmware version: 15.26.7.p189
The combo image can be downloaded through either WLAN or
Bluetooth.
SD-8801:
WLAN (SD8801) firmware version: W14.68.36.p204
These devices are WLAN only.
SDSD-8787:
WLAN (SDIO) firmware version: W14.68.35.p66
Bluetooth (SDIO) firmware version: 14.68.35.p66
The combo image can be downloaded through either WLAN or
Bluetooth.
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
USB-USB8997:
WLAN (USB) firmware version: W16.68.1.p183
Bluetooth (USB) firmware version: 16.26.1.p183
Both WLAN and bluetooth are on USB interface.
The combo image will be downloaded through WLAN only.
PCIe-USB8897:
WLAN (PCIe) firmware version: W15.68.19.p21
Bluetooth (USB) firmware version: 15.28.19.p21
The combo image will be downloaded through WLAN only
PCIe8997:
WLAN (PCIe) firmware version: W16.68.1.p195
During PCIe reset, wifi-only firmware will be download to device
in case bluetooth part do not get affected.
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
Fixes DMAR errors that occurred when using the firmware
with DPDK applications.
Signed-off-by: Louis Peens <louis.peens@netronome.com>
Tested-by: Brendan Galloway <brendan.galloway@netronome.com>
Acked-by: Edwin Peer <edwin.peer@netronome.com>
The following fw files are added to support QCA6174.
rampatch_00440302.bin: RAM DUMP
nvm_00440302.bin: NVRAM
Signed-off-by: Balakrishna Godavarthi <bgodavar@codeaurora.org>
Add AMD Secure Encrypted Virtualization (SEV) firmware to allow for the
updating of the SEV firmware outside of BIOS releases. Naming convention
and directory structure follows the convention defined in the kernel
driver in drivers/crypto/ccp/psp-dev.c
SEV firmware files are to be placed in the "amd" directory and names
should follow the pattern: amd_sev_fam<FAMILY>h_model<MODEL>h.sbin
where FAMILY is the two-digit hexadecimal value of the target processor
family (e.g. 17)
where MODEL is the two-digit hexadecimal value of the target processor
model (e.g. 01) or where the least significant nibble of the two-digit
hexadecimal value can be an 'x' to indicate a range of models
(e.g. 0x for 00 to of).
The firmware provided is version 0.17 build 11 and is for AMD family
17h processors with models in the range 00h to 0fh.
Signed-off-by: John Allen <john.allen@amd.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
Delete the reference to an amdgpu file that was removed, and fix
the missing quote for one of the raspberrypi files.
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9560
Also it is known as Intel JeffersonPeak (JfP).
FW Build: REL0395
Release Version: 20.110.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9260
Also it is known as Intel ThunderPeak (THP).
FW Build: REL0395
Release Version: 20.110.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
These NVIDIA-signed firmwares are required to enable the Cypress
Type-C controller on TU10x GPUs.
FW versions:
Secondary: 42
Primary: 3.1.10
Signed-off-by: Ajay Gupta <ajayg@nvidia.com>
This patch adds new FW for bnx2x, which adds the following:
- TX VLAN filtering support.
- Enable TPA only for packets without VLAN.
It also addresses few critical issues,
- Fairness algorithm misbehaviour when minimum bandwidth configured
for all PFs.
- Error recovery issue on TAPE devices.
- FW not discarding FIP frames that are not designated to PF.
- Kernel driver initialization failure after preboot driver.
- VxLAN stops working after sending inner IP fragmented traffic.
- Issues in the following FW flows:
SD VLAN update, TX packet drop, packet padding flow, vlan add/remove.
Signed-off-by: Sudarsana Reddy Kalluru <Sudarsana.Kalluru@cavium.com>
Signed-off-by: Ariel Elior <Ariel.Elior@cavium.com>
Signed-off-by: Rahul Verma <Rahul.Verma@cavium.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
WLAN (PCIe) firmware version: W16.68.1.p195
Bluetooth (USB) firmware version: 16.26.1.p195
In PCIe-USB chipset, WLAN is over PCIe whereas bluetooth is over
USB. The combo image will be downloaded through WLAN only.
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
WLAN (SDIO) firmware version: W15.68.19.17
Bluetooth (SDIO) firmware version: 15.26.19.17
The combo image can be downloaded through either WLAN or
Bluetooth.
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
WLAN (SDIO) firmware version: W16.68.1.p195
Bluetooth (SDIO) firmware version: 16.26.1.p195
Both WLAN and bluetooth are on SDIO interface.
The combo image can be downloaded either through WLAN or
Bluetooth.
Signed-off-by: Cathy Luo <cluo@marvell.com>
Signed-off-by: Hemantkumar Suthar <shemant@marvell.com>
Signed-off-by: Ganapathi Bhat <gbhat@marvell.com>
BCM43430 NVRAM config file for the RPi3 Model B was set to the value
found by brcmf_dmi_probe(), but should use the DT compatible.
Rename the file to actually make it work with the kernel driver.
Signed-off-by: Matthias Brugger <mbrugger@suse.com>
This patch updates the firmware file for Intel Bluetooth 8265
Also it is known as Intel WindStormPeak (WsP).
FW Build: REL0295
Release Version: 20.100.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 8260
also it is known as Intel Snowfield Peak (SfP)
FW Build: REL0522
Release Version: 20.100.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9260
Also it is known as Intel ThunderPeak (THP).
FW Build: REL0386
Release Version: 20.100.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
This patch updates the firmware file for Intel Bluetooth 9560
Also it is known as Intel JeffersonPeak (JfP).
FW Build: REL0386
Release Version: 20.100.0.3
Signed-off-by: Amit K Bag <amit.k.bag@intel.com>
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
- Add NVRAM for BCM43430 used by Raspberry Pi 3 Model B
-----BEGIN PGP SIGNATURE-----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=X7VX
-----END PGP SIGNATURE-----
Merge tag 'add-rpi-fw' of ssh://gitolite.kernel.org/pub/scm/linux/kernel/git/matthias.bgg/linux-firmware
- Add NVRAM for BCM43455 used by Raspberry Pi 3 Model B+
- Add NVRAM for BCM43430 used by Raspberry Pi 3 Model B
Signed-off-by: Josh Boyer <jwboyer@kernel.org>
Add new versions of the firmwares for 9260 and 9000.
Build number: Core_build_core40-120
Revision numbers: 95eb4e97 (9260, 9000)
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Ryder Lee
Josh Boyer
Ganapathi Bhat
Louis Peens
Vishal Kulkarni
Amit K Bag
Larry Finger
Balakrishna Godavarthi
Allen, John
Ajay Gupta
Rahul Verma
Alex Deucher
Kalle Valo
Matthias Brugger
Emmanuel Grumbach