60 lines
1.4 KiB
INI
60 lines
1.4 KiB
INI
# SPDX-License-Identifier: GPL-2.0-or-later
|
|
|
|
# The Broadcom chip used in the Raspberry Pi 2 Model B
|
|
|
|
# Partial information is available in raspberry pi website:
|
|
# https://www.raspberrypi.org/documentation/hardware/raspberrypi/bcm2836
|
|
|
|
if { [info exists CHIPNAME] } {
|
|
set _CHIPNAME $CHIPNAME
|
|
} else {
|
|
set _CHIPNAME bcm2836
|
|
}
|
|
|
|
if { [info exists CHIPCORES] } {
|
|
set _cores $CHIPCORES
|
|
} else {
|
|
set _cores 4
|
|
}
|
|
|
|
if { [info exists USE_SMP] } {
|
|
set _USE_SMP $USE_SMP
|
|
} else {
|
|
set _USE_SMP 0
|
|
}
|
|
|
|
if { [info exists DAP_TAPID] } {
|
|
set _DAP_TAPID $DAP_TAPID
|
|
} else {
|
|
set _DAP_TAPID 0x4ba00477
|
|
}
|
|
|
|
jtag newtap $_CHIPNAME cpu -expected-id $_DAP_TAPID -irlen 4
|
|
adapter speed 4000
|
|
|
|
dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
|
|
|
|
# MEM-AP for direct access
|
|
target create $_CHIPNAME.ap mem_ap -dap $_CHIPNAME.dap -ap-num 0
|
|
|
|
# these addresses are obtained from the ROM table via 'dap info 0' command
|
|
set _DBGBASE {0x80010000 0x80012000 0x80014000 0x80016000}
|
|
|
|
set _smp_command "target smp"
|
|
|
|
for { set _core 0 } { $_core < $_cores } { incr _core } {
|
|
set _TARGETNAME $_CHIPNAME.cpu$_core
|
|
|
|
target create $_TARGETNAME cortex_a -dap $_CHIPNAME.dap -coreid $_core -dbgbase [lindex $_DBGBASE $_core]
|
|
$_TARGETNAME configure -event reset-assert-post { cortex_a dbginit }
|
|
|
|
set _smp_command "$_smp_command $_CHIPNAME.cpu$_core"
|
|
}
|
|
|
|
if {$_USE_SMP} {
|
|
eval $_smp_command
|
|
}
|
|
|
|
# default target is cpu0
|
|
targets $_CHIPNAME.cpu0
|