Previously, if a pin was configured as ADAPTER_GPIO_INIT_STATE_INPUT and
its drive value was ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL, initialize_gpio
would configure the pin as an output.
The set_gpio_value function is optimized to not set the direction for
pins configured as ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL as it only needs to
be set once. When initialize_gpio performs this setup, it checked only
that the drive value was ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL to set the
output direction but did not exclude input pins which have already had
their direction set.
Now, input pins are ignored when initialize_gpio checks for
ADAPTER_GPIO_DRIVE_MODE_PUSH_PULL to set the mode to output.
Fixes: ace028262b ("drivers/am335xgpio: Migrate to adapter gpio commands")
Change-Id: I9ea502c400ea4ffae37080b9cee891ca9176a47d
Signed-off-by: Vincent Fazio <vfazio@xes-inc.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/7877
Reviewed-by: Tomas Vanek <vanekt@fbl.cz>
Tested-by: jenkins
Reviewed-by: Steve Marple <stevemarple@googlemail.com>
51d4996c5b