tcl at91samdXX.cfg: update config to current OpenOCD status
Remove comment about workaround of not working 'reset halt' - not needed as 'reset halt' is working as expected @ EDBG with srst_only. Add srst_pulls_trst to reset_config as it no more triggers an error. Change-Id: I47cf445690c46ccfb866900cddbfcaefc8649f82 Signed-off-by: Tomas Vanek <vanekt@fbl.cz> Reviewed-on: http://openocd.zylin.com/3722 Tested-by: jenkins Reviewed-by: Andreas Fritiofson <andreas.fritiofson@gmail.com>
This commit is contained in:
parent
bcaf775fc1
commit
25d7ba19c9
|
@ -50,13 +50,7 @@ $_TARGETNAME configure -event reset-deassert-post {
|
|||
}
|
||||
|
||||
# SRST (wired to RESET_N) resets debug circuitry
|
||||
# srst_pulls_trst is not configured here to avoid an error raised in reset halt
|
||||
reset_config srst_gates_jtag
|
||||
|
||||
# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) cannot
|
||||
# stop the MCU before it starts executing code if hardware RESETN
|
||||
# line is configured by command "reset_config srst_only"
|
||||
# Use "reset_config none" (default) before flash programming.
|
||||
reset_config srst_gates_jtag srst_pulls_trst
|
||||
|
||||
# Do not use a reset button with other SWD adapter than Atmel's EDBG.
|
||||
# DSU usually locks MCU in reset state until you issue a reset command
|
||||
|
|
Loading…
Reference in New Issue