diff --git a/tcl/target/stm32u0x.cfg b/tcl/target/stm32u0x.cfg
new file mode 100644
index 000000000..d3aaed3cb
--- /dev/null
+++ b/tcl/target/stm32u0x.cfg
@@ -0,0 +1,55 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
+# Configuration file for STM32U0x series.
+#
+# STM32U0 devices support only SWD transport.
+#
+
+source [find mem_helper.tcl]
+
+if { [info exists CHIPNAME] } {
+	set _CHIPNAME $CHIPNAME
+} else {
+	set _CHIPNAME stm32u0x
+}
+
+# Work-area is a space in RAM used for flash programming, by default use 4 KiB.
+if { [info exists WORKAREASIZE] } {
+   set _WORKAREASIZE $WORKAREASIZE
+} else {
+   set _WORKAREASIZE 0x1000
+}
+
+if { [info exists CPUTAPID] } {
+   set _CPUTAPID $CPUTAPID
+} else {
+   set _CPUTAPID 0x6ba02477
+}
+
+swd newdap $_CHIPNAME cpu -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
+
+set _TARGETNAME $_CHIPNAME.cpu
+target create $_TARGETNAME cortex_m -endian little -dap $_CHIPNAME.dap
+
+$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
+
+flash bank $_CHIPNAME.flash stm32l4x 0x08000000 0 0 0 $_TARGETNAME
+flash bank $_CHIPNAME.otp   stm32l4x 0x1FFF6800 0 0 0 $_TARGETNAME
+
+adapter speed 2000
+
+if {![using_hla]} {
+	# Use SYSRESETREQ to perform a soft reset if SRST is not fitted.
+	cortex_m reset_config sysresetreq
+}
+
+$_TARGETNAME configure -event examine-end {
+	# Enable debug during low power modes (uses more power).
+	# DBGMCU_CR |= DBG_STANDBY | DBG_STOP
+	mmw 0x40015804 0x00000006 0
+
+	# Stop watchdog counters when core is halted.
+	# DBGMCU_APB1_FZR |= DBG_IWDG_STOP | DBG_WWDG_STOP
+	mmw 0x40015808 0x00001800 0
+}