riscv-openocd/tcl/target/stm32_stlink.cfg

#
# stm32 stlink pseudo target
#

if { [info exists CHIPNAME] } {
   set _CHIPNAME $CHIPNAME
} else {
   set _CHIPNAME stm32f1x
}

# Work-area is a space in RAM used for flash programming
# By default use 4kB (as found on some STM32F100s)
if { [info exists WORKAREASIZE] } {
   set _WORKAREASIZE $WORKAREASIZE
} else {
   set _WORKAREASIZE 0x1000
}

if { [info exists CPUTAPID] } {
   set _CPUTAPID $CPUTAPID
} else {
   # this is the SW-DP tap id not the jtag tap id
   set _CPUTAPID 0x1ba01477
}

if { [info exists TRANSPORT] } {
   set _TRANSPORT $TRANSPORT
   if { $TRANSPORT == "hla_jtag" } {
      if { [info exists CPUTAPID] == 0 } {
         # jtag requires us to use the jtag tap id
         set _CPUTAPID 0x3ba00477
      }
   }
} else {
   set _TRANSPORT hla_swd
}

# add deprecated transport name check
if { $_TRANSPORT == "stlink_swd" } {
	set _TRANSPORT "hla_swd"
	echo "DEPRECATED! use 'hla_swd' transport not 'stlink_swd'"
}

if { $_TRANSPORT == "stlink_jtag" } {
	set _TRANSPORT "hla_jtag"
	echo "DEPRECATED! use 'hla_jtag' transport not 'stlink_jtag'"
}
# end deprecated checks

#
# possibles value are hla_swd or hla_jtag
#
transport select $_TRANSPORT

hla newtap $_CHIPNAME cpu -expected-id $_CPUTAPID

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME hla_target -chain-position $_TARGETNAME

$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0