riscv-openocd/tcl/board/hilscher_nxhx10.cfg

################################################################################
# Author: Michael Trensch (MTrensch@googlemail.com)
################################################################################

source [find target/hilscher_netx10.cfg]

# Usually it is not needed to set srst_pulls_trst
# but sometimes it does not work without it. If you encounter
# problems try to line below
# reset_config trst_and_srst srst_pulls_trst
reset_config trst_and_srst
adapter srst delay 500
jtag_ntrst_delay 500

$_TARGETNAME configure -work-area-virt 0x08000000 -work-area-phys 0x08000000 -work-area-size 0x4000 -work-area-backup 1

# Par. Flash can only be accessed if DIP switch on the board is set in proper
# position and init_sdrambus was called. Don't call these functions if the DIP
# switch is in invalid position, as some outputs may collide. This is why this
# function is not called automatically
proc flash_init { } {
  puts "Configuring SRAM nCS0 for 90ns Par. Flash (x16)"
  mww 0x101C0100 0x01010008

  flash probe 0
}

proc mread32 {addr} {
  return [read_memory $addr 32 1]
}

proc init_clocks { } {
  puts "Enabling all clocks "
  set accesskey [mread32 0x101c0070]
  mww  0x101c0070 $accesskey

  mww  0x101c0028 0x00007511
}

proc init_sdrambus { } {
  puts "Initializing external SDRAM Bus 16 Bit "
  set accesskey [mread32 0x101c0070]
  mww  0x101c0070 $accesskey
  mww  0x101c0C40 0x00000050

  puts "Configuring SDRAM controller for K4S561632E (32MB) "
  mww 0x101C0140 0
  sleep 100
  #mww 0x101C0144 0x00a13262
  mww 0x101C0144 0x00a13251
  mww 0x101C0148 0x00000033
  mww 0x101C0140 0x030d0121
}

$_TARGETNAME configure -event reset-init {
  halt
  wait_halt 1000

  arm7_9 fast_memory_access enable
  arm7_9 dcc_downloads enable

  init_clocks
#  init_sdrambus

  puts ""
  puts "-------------------------------------------------"
  puts "Call 'init_clocks' to enable all clocks"
  puts "Call 'init_sdrambus' to enable external SDRAM bus"
  puts "-------------------------------------------------"
}

#####################
# Flash configuration
#####################

#flash bank <name> <driver> <base> <size> <chip width> <bus width> <target#>
#flash bank parflash cfi 0xC0000000 0x01000000 2 2 $_TARGETNAME

init
reset init