riscv-openocd/tcl/board/at91rm9200-ek.cfg

#
# Copyright 2010 Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
#
# under GPLv2 Only
#
# This is for the "at91rm9200-ek" eval board.
#
#
# It has atmel at91rm9200 chip.
source [find target/at91rm9200.cfg]

reset_config trst_and_srst

$_TARGETNAME configure -event gdb-attach { reset init }
$_TARGETNAME configure -event reset-init { at91rm9200_ek_init }

## flash bank <name> <driver> <base> <size> <chip_width> <bus_width> <target>
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME cfi 0x10000000 0x00800000 2 2 $_TARGETNAME

# The chip may run @ 32khz, so set a really low JTAG speed
adapter speed 8

proc at91rm9200_ek_init { } {
	# Try to run at 1khz... Yea, that slow!
	# Chip is really running @ 32khz
	adapter speed 8

	mww 0xfffffc64 0xffffffff
	## disable all clocks but system clock
	mww 0xfffffc04 0xfffffffe
	## disable all clocks to pioa and piob
	mww 0xfffffc14 0xffffffc3
	## master clock = slow cpu = slow
	## (means the CPU is running at 32khz!)
	mww 0xfffffc30 0
	## main osc enable
	mww 0xfffffc20 0x0000ff01
	## MC_PUP
	mww 0xFFFFFF50 0x00000000
	## MC_PUER: Memory controller protection unit disable
	mww 0xFFFFFF54 0x00000000
	## EBI_CFGR
	mww 0xFFFFFF64 0x00000000
	## SMC2_CSR[0]: 16bit, 2 TDF, 4 WS
	mww 0xFFFFFF70 0x00003284

	## Init Clocks
	## CKGR_PLLAR
	mww 0xFFFFFC28 0x2000BF05
	## PLLAR: 179,712000 MHz for PCK
	mww 0xFFFFFC28 0x20263E04
	sleep 100
	## PMC_MCKR
	mww 0xFFFFFC30 0x00000100
	sleep 100
	## ;MCKR : PCK/3 = MCK Master Clock = 59,904000MHz from PLLA
	mww 0xFFFFFC30 0x00000202
	sleep 100

	#========================================
	# CPU now runs at 180mhz
	# SYS runs at 60mhz.
	adapter speed 40000
	#========================================

	## Init SDRAM
	## PIOC_ASR: Configure PIOC as peripheral (D16/D31)
	mww 0xFFFFF870 0xFFFF0000
	## PIOC_BSR:
	mww 0xFFFFF874 0x00000000
	## PIOC_PDR:
	mww 0xFFFFF804 0xFFFF0000
	## EBI_CSA : CS1=SDRAM
	mww 0xFFFFFF60 0x00000002
	## EBI_CFGR:
	mww 0xFFFFFF64 0x00000000
	## SDRC_CR :
	mww 0xFFFFFF98 0x2188c155
	## SDRC_MR : Precharge All
	mww 0xFFFFFF90 0x00000002
	## access SDRAM
	mww 0x20000000 0x00000000
	## SDRC_MR : Refresh
	mww 0xFFFFFF90 0x00000004
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
	## SDRC_MR : Load Mode Register
	mww 0xFFFFFF90 0x00000003
	## access SDRAM
	mww 0x20000080 0x00000000
	## SDRC_TR : Write refresh rate
	mww 0xFFFFFF94 0x000002E0
	## access SDRAM
	mww 0x20000000 0x00000000
	## SDRC_MR : Normal Mode
	mww 0xFFFFFF90 0x00000000
	## access SDRAM
	mww 0x20000000 0x00000000
}