This changes how the downloader works, a little bit. Previously, when block sync started,
we immediately started filling up to 8192 blocks. Usually this is fine, blocks are small
in the early numbers. The threshold then is lowered as we measure the size of the blocks
that are filled.
However, if the node is shut down and restarts syncing while we're in a heavy segment,
that might be bad. This PR introduces a more conservative initial threshold of 2K blocks
instead.
* init
notes
removed some mentions of eth62, bumped protocol err too old to >=63
* remove sanity checks and bump supported protocol version up to 63
* remove 62 tests, still need to add 65
* remove 65 tests
* eth/downloader: refactor downloader + queue
downloader, fetcher: throttle-metrics, fetcher filter improvements, standalone resultcache
downloader: more accurate deliverytime calculation, less mem overhead in state requests
downloader/queue: increase underlying buffer of results, new throttle mechanism
eth/downloader: updates to tests
eth/downloader: fix up some review concerns
eth/downloader/queue: minor fixes
eth/downloader: minor fixes after review call
eth/downloader: testcases for queue.go
eth/downloader: minor change, don't set progress unless progress...
eth/downloader: fix flaw which prevented useless peers from being dropped
eth/downloader: try to fix tests
eth/downloader: verify non-deliveries against advertised remote head
eth/downloader: fix flaw with checking closed-status causing hang
eth/downloader: hashing avoidance
eth/downloader: review concerns + simplify resultcache and queue
eth/downloader: add back some locks, address review concerns
downloader/queue: fix remaining lock flaw
* eth/downloader: nitpick fixes
* eth/downloader: remove the *2*3/4 throttling threshold dance
* eth/downloader: print correct throttle threshold in stats
Co-authored-by: Péter Szilágyi <peterke@gmail.com>
This change introduces garbage collection for the light client. Historical
chain data is deleted periodically. If you want to disable the GC, use
the --light.nopruning flag.
This fixes two issues with state sync restarts:
When sync restarts with a new root, some peers can have in-flight requests.
Since all peers with active requests were marked idle when exiting sync,
the new sync would schedule more requests for those peers. When the
response for the earlier request arrived, the new sync would reject it and
mark the peer idle again, rendering the peer useless until it disconnected.
The other issue was that peers would not be marked idle when they had
delivered a response, but the response hadn't been processed before
restarting the state sync. This also made the peer useless because it
would be permanently marked busy.
Co-authored-by: Felix Lange <fjl@twurst.com>
* eth/downloaded: fixed datarace between synchronize and Progress
There was a race condition between `downloader.synchronize()` and `Progress` `syncWithPeer` `fetchHeight` `findAncestors` and `processHeaders`
This PR changes the behavior of the downloader a bit.
Previously the functions `Progress` `syncWithPeer` `fetchHeight` `findAncestors` and `processHeaders` read the syncMode anew within their loops. Now they read the syncMode at the start of their function and don't change it during their runtime.
* eth/downloaded: comment
* eth/downloader: added comment
This PR makes use of go 1.13 error handling, wrapping errors and using
errors.Is to check a wrapped root-cause. It also removes the travis
builders for go 1.11 and go 1.12.
* core, eth: some fixes for freezer
* vendor, core/rawdb, cmd/geth: add db inspector
* core, cmd/utils: check ancient store path forceily
* cmd/geth, common, core/rawdb: a few fixes
* cmd/geth: support windows file rename and fix rename error
* core: support ancient plugin
* core, cmd: streaming file copy
* cmd, consensus, core, tests: keep genesis in leveldb
* core: write txlookup during ancient init
* core: bump database version
* all: freezer style syncing
core, eth, les, light: clean up freezer relative APIs
core, eth, les, trie, ethdb, light: clean a bit
core, eth, les, light: add unit tests
core, light: rewrite setHead function
core, eth: fix downloader unit tests
core: add receipt chain insertion test
core: use constant instead of hardcoding table name
core: fix rollback
core: fix setHead
core/rawdb: remove canonical block first and then iterate side chain
core/rawdb, ethdb: add hasAncient interface
eth/downloader: calculate ancient limit via cht first
core, eth, ethdb: lots of fixes
* eth/downloader: print ancient disable log only for fast sync
* core, eth, trie: bloom filter for trie node dedup during fast sync
* eth/downloader, trie: address review comments
* core, ethdb, trie: restart fast-sync bloom construction now and again
* eth/downloader: initialize fast sync bloom on startup
* eth: reenable eth/62 until we properly remove it
* cmd, eth: Added in the flag to step geth once sync based on input
* cmd, eth: 16400 Add an option to stop geth once in sync.
* cmd: 16400 Add an option to stop geth once in sync. WIP
* cmd/geth/main, les/fletcher: added in light mode support
* cmd/geth/main, les/fletcher: Cleaned Comments and code for light mode
* cmd: 16400 Fixed formatting issue and cleaned code
* cmd, eth, les: 16400 Fixed formatting issues
* cmd, eth, les: Performed gofmt to update formatting
* cmd, eth, les: Fixed bugs resulting formatting
* cmd/geth, eth/, les: switched to downloader event
* eth: Fixed styling and gen_config
* eth/: Fix nil error in config file
* cmd/geth: Updated countdown log
* les/fetcher.go: Removed depcreated channel
* eth/downloader.go: Removed deprecated select
* cmd/geth, cmd/utils: Fixed minor issues
* eth: Reverted config files to proper format
* eth: Fixed typo in config file
* cmd/geth, eth/down: Updated code to use header time stamp
* eth/downloader: Changed the time threshold to 10 minutes
* cmd/geth, eth/downloader: Updated downloading event to pass latest header
* cmd/geth: Updated main to use right timer object
* cmd/geth: Removed unused failed event
* cmd/geth: added in correct time field with type assertion
* cmd/geth, cmd/utils: Updated flag to use boolean
* cmd/geth, cmd/utils, eth/downloader: Cleaned up code based on recommendations
* cmd/geth: Removed unneeded import
* cmd/geth, eth/downloader: fixed event field and suggested changes
* cmd/geth, cmd/utils: Updated flag and linting issue
* ethdb: add Putter interface and Has method
* ethdb: improve docs and add IdealBatchSize
* ethdb: remove memory batch lock
Batches are not safe for concurrent use.
* core: use ethdb.Putter for Write* functions
This covers the easy cases.
* core/state: simplify StateSync
* trie: optimize local node check
* ethdb: add ValueSize to Batch
* core: optimize HasHeader check
This avoids one random database read get the block number. For many uses
of HasHeader, the expectation is that it's actually there. Using Has
avoids a load + decode of the value.
* core: write fast sync block data in batches
Collect writes into batches up to the ideal size instead of issuing many
small, concurrent writes.
* eth/downloader: commit larger state batches
Collect nodes into a batch up to the ideal size instead of committing
whenever a node is received.
* core: optimize HasBlock check
This avoids a random database read to get the number.
* core: use numberCache in HasHeader
numberCache has higher capacity, increasing the odds of finding the
header without a database lookup.
* core: write imported block data using a batch
Restore batch writes of state and add blocks, tx entries, receipts to
the same batch. The change also simplifies the miner.
This commit also removes posting of logs when a forked block is imported.
* core: fix DB write error handling
* ethdb: use RLock for Has
* core: fix HasBlock comment
* eth/downloader: separate state sync from queue
Scheduling of state node downloads hogged the downloader queue lock when
new requests were scheduled. This caused timeouts for other requests.
With this change, state sync is fully independent of all other downloads
and doesn't involve the queue at all.
State sync is started and checked on in processContent. This is slightly
awkward because processContent doesn't have a select loop. Instead, the
queue is closed by an auxiliary goroutine when state sync fails. We
tried several alternatives to this but settled on the current approach
because it's the least amount of change overall.
Handling of the pivot block has changed slightly: the queue previously
prevented import of pivot block receipts before the state of the pivot
block was available. In this commit, the receipt will be imported before
the state. This causes an annoyance where the pivot block is committed
as fast block head even when state downloads fail. Stay tuned for more
updates in this area ;)
* eth/downloader: remove cancelTimeout channel
* eth/downloader: retry state requests on timeout
* eth/downloader: improve comment
* eth/downloader: mark peers idle when state sync is done
* eth/downloader: move pivot block splitting to processContent
This change also ensures that pivot block receipts aren't imported
before the pivot block itself.
* eth/downloader: limit state node retries
* eth/downloader: improve state node error handling and retry check
* eth/downloader: remove maxStateNodeRetries
It fails the sync too much.
* eth/downloader: remove last use of cancelCh in statesync.go
Fixes TestDeliverHeadersHang*Fast and (hopefully)
the weird cancellation behaviour at the end of fast sync.
* eth/downloader: fix leak in runStateSync
* eth/downloader: don't run processFullSyncContent in LightSync mode
* eth/downloader: improve comments
* eth/downloader: fix vet, megacheck
* eth/downloader: remove unrequested tasks anyway
* eth/downloader, trie: various polishes around duplicate items
This commit explicitly tracks duplicate and unexpected state
delieveries done against a trie Sync structure, also adding
there to import info logs.
The commit moves the db batch used to commit trie changes one
level deeper so its flushed after every node insertion. This
is needed to avoid a lot of duplicate retrievals caused by
inconsistencies between Sync internals and database. A better
approach is to track not-yet-written states in trie.Sync and
flush on commit, but I'm focuing on correctness first now.
The commit fixes a regression around pivot block fail count.
The counter previously was reset to 1 if and only if a sync
cycle progressed (inserted at least 1 entry to the database).
The current code reset it already if a node was delivered,
which is not stong enough, because unless it ends up written
to disk, an attacker can just loop and attack ad infinitum.
The commit also fixes a regression around state deliveries
and timeouts. The old downloader tracked if a delivery is
stale (none of the deliveries were requestedt), in which
case it didn't mark the node idle and did not send further
requests, since it signals a past timeout. The current code
did mark it idle even on stale deliveries, which eventually
caused two requests to be in flight at the same time, making
the deliveries always stale and mass duplicating retrievals
between multiple peers.
* eth/downloader: fix state request leak
This commit fixes the hang seen sometimes while doing the state
sync. The cause of the hang was a rare combination of events:
request state data from peer, peer drops and reconnects almost
immediately. This caused a new download task to be assigned to
the peer, overwriting the old one still waiting for a timeout,
which in turned leaked the requests out, never to be retried.
The fix is to ensure that a task assignment moves any pending
one back into the retry queue.
The commit also fixes a regression with peer dropping due to
stalls. The current code considered a peer stalling if they
timed out delivering 1 item. However, the downloader never
requests only one, the minimum is 2 (attempt to fine tune
estimated latency/bandwidth). The fix is simply to drop if
a timeout is detected at 2 items.
Apart from the above bugfixes, the commit contains some code
polishes I made while debugging the hang.
* core, eth, trie: support batched trie sync db writes
* trie: rename SyncMemCache to syncMemBatch
* accounts, cmd, eth, ethdb: port logs over to new system
* ethdb: drop concept of cache distribution between dbs
* eth: fix some log nitpicks to make them nicer
Reworked the EVM gas instructions to use 64bit integers rather than
arbitrary size big ints. All gas operations, be it additions,
multiplications or divisions, are checked and guarded against 64 bit
integer overflows.
In additon, most of the protocol paramaters in the params package have
been converted to uint64 and are now constants rather than variables.
* common/math: added overflow check ops
* core: vmenv, env renamed to evm
* eth, internal/ethapi, les: unmetered eth_call and cancel methods
* core/vm: implemented big.Int pool for evm instructions
* core/vm: unexported intPool methods & verification methods
* core/vm: added memoryGasCost overflow check and test
Reworked the EVM gas instructions to use 64bit integers rather than
arbitrary size big ints. All gas operations, be it additions,
multiplications or divisions, are checked and guarded against 64 bit
integer overflows.
In additon, most of the protocol paramaters in the params package have
been converted to uint64 and are now constants rather than variables.
* common/math: added overflow check ops
* core: vmenv, env renamed to evm
* eth, internal/ethapi, les: unmetered eth_call and cancel methods
* core/vm: implemented big.Int pool for evm instructions
* core/vm: unexported intPool methods & verification methods
* core/vm: added memoryGasCost overflow check and test
gary rong
Péter Szilágyi
Martin Holst Swende
rene
Marius van der Wijden
Martin Michlmayr
Guillaume Ballet
Christian Muehlhaeuser
Matthew Halpern
lhendre
Wenbiao Zheng
williambannas
kiel barry
Domino Valdano
Yusup
Anton Evangelatov
jtakalai
ferhat elmas
Felix Lange
Nick Johnson
Jeffrey Wilcke
zsfelfoldi
Felix Lange